May 14, 2008

Wedding DIY: Ribbon Flower How-To

I love the look and ease of making homemade ribbon flowers, but seldom have the occasion. So when wedding season rolled around here at the NewNew, I was happy to have an excuse to share a couple with you.

The only supplies and skills that you need are ribbon (I prefer it with wires removed if it is floral wire, but that is to taste), needle, thread, beads and the ability to sew a running stitch.

****************************************************
Primrose (4-petal flower)
****************************************************



Start with 4 pieces of ribbon cut to 3.5" lengths. The dotted line indicates the stitching path you will take. You don't really need to mark it, I just keep it approximately 1/8" from the finished edge and 1/4 from the raw edge.



Start with the first petal and do a running stitch around the 3 edges. Pull thread tightly when you reach the end.



Sew one loop through the gathered ribbon to keep the petal together tightly. Without cutting thread, repeat on the next piece of ribbon, pulling it next to your first one. Remember to sew the loop between petals and repeat for petals #3 and #4.



Sew #4 to your first petal in a ring. Add a few additional stitches to keep the center together adding beads to some of the stitches. Tie off your thread at the back with a knot and admire your handiwork!



****************************************************
Daffodil or Fuchsia (5-petal with trumpet center)
****************************************************



Cut one 10" length of ribbon, marking lightly in pencil every 2" of your outer edge of the finished flower. The dotted line across the top is the stitch line for the trumpet, which you can mark if you need a guide (I like to freehand it).



Sew your ribbon into a ring with a running stitch and pull thread tight. Follow along your trumpet stitch line all the way around the ring.



Before you pull the thread tight, flip your trumpet edge through the center so the raw edges are on the under side of your flower. Pull the thread tight and it should look like the picture on the right.



Sew out to one of your marks from the center of the to the edge and pull tight. Like in the primrose, sew a loop to secure. Repeat at all 4 remaining marks (the 4th is your stitch that made the ribbon into a ring). Then add beads to the center to style your flower.




I glued together a few of these flowers along with a ribbon to make a simple bridal hair clip. The addition of the blue ribbon is so it can qualify as the traditional "something blue." Ribbon flowers would also make a fabulous veil base, boutonniere, mother-of-the-bride corsage, wedding favor, etc.



Why not dress up your creations with some beads from the {NewNew} team?

SweetSwoozie for crystal or GlassHouseSupplies for something more colorful.


-Kari
ikyoto.etsy.com

4 comments:

KimmChi said...

Wow - these look really stellar!

nordeasoaperie said...

nice tutorial....looks like something I can actually do!

Katy Reiser said...

ummm, these are pretty darn rad! thanks for sharing!

Iris said...

oh!!! love it! so beautiful, thanks for sharing!!!